Technical Notes

 
Parameter loading procedure for 04PC

 

AESI Service Department Customer Support -- Tech Note: P001-04PC
 
Applies to: Fanuc 04PC Control.
Last updated: December 27, 1996.

SUMMARY

The following procedure will step you through reloading parameters on the Fanuc 04PC control. For instructions on editing parameters please go to  Editing Parameters 

Note: If you do not have parameter tapes or disks, you can download them from our Parameter site.

PROCEDURE

1.
 Locate the parameter tapes inside the control. They are usually located in a bag inside the control cabinet. There are also altered parameter data sheets located behind one of the doors on the control.
2.
 There are several parameters that may have been altered over time and should be recorded if you can access your parameter pages. To check the parameter page, first go to the alarm page if not already there and press the "FUNC." key along with the "ALARM" key. Press the "Parameter" soft key located under the CRT screen. You now should be on the parameter page. Try to page down to access more parameters.
3.
 Record the following parameters to put in by hand at a later date.

 
P0000
P0001
P0002
P0003
P0004
P0005
P0067
P0068
P0082
P0083
P0084
P0085
P0090
P0109
P0110
P0111
P0117
P0118
P0190
P0191
P0194
P0196
P0310
P0311
P0312
P0313
P0318
P0535
P0536
P0541
P0586
P0736
P0811
P0993
P4005
P4024
P4025
P4026
P8144
P8244
P8344
_
 		  

Copyright© 2025 AMADA CANADA, INC. All Rights Reserved.